1/13/2024 0 Comments Using snmpv3 to get systemname![]() If the controller will be sending SNMP traps, click Add in the Trap Receivers section to add a trap receiver. Navigate to the Configuration > Management > SNMP page. If messages sent on behalf of this user can be encrypted/decrypted with DES, the (private) privacy key for use with the privacy protocol.įollow the steps below to configure a controller’s basic SNMP parameters. This takes the value DES (CBC-DES Symmetric Encryption Protocol). This is a string password for MD5 or SHA depending on the choice above.Īn indication of whether messages sent on behalf of this user can be protected from disclosure, and if so, the type of privacy protocol which is used. If messages sent on behalf of this user can be authenticated, the (private) authentication key for use with the authentication protocol. SHA: HMAC-SHA-96 Digest Authentication Protocol MD5: HMAC-MD5-96 Digest Authentication Protocol If you are using SNMPv3 to obtain values from the controller, you can configure the following parameters:Ī string representing the name of the user.Īn indication of whether messages sent on behalf of this user can be authenticated, and if so, the type of authentication protocol used. This is optional, and will use the default port number if not modified by the user. UDP port on which the trap receiver is listening for traps. Type: Trap or Inform (SNMP v2c or SNMPv3 only) Configure the following for each host/trap receiver: This host needs to be running a trap receiver to receive and interpret the traps sent by the Aruba controller. Refer to the list of traps in the “SNMP traps” section below for a list of traps that are generated by the controller. NOTE: This is needed only if using SNMP v2c and is not needed if using version 3.Įnables generation of SNMP traps to configured SNMP trap receivers. String to describe the location of the controller.Ĭommunity strings used to authenticate requests for SNMP versions before version 3. Name of the person who acts as the System Contact or administrator for the controller. Table 1: SNMP Parameters for the Controller You can configure the following SNMP parameters for the controller. See the ArubaOS MIB Reference Guide for information about the Aruba MIBS and SNMP traps. MIB Reference Guide for information about the Aruba MIBs and SNMP traps.Īruba-specific management information bases (MIBs) describe the objects that can be managed using SNMP. In other words, SNMP cannot be used for setting values in a n Aruba system in the current ArubaOS version. Aruba controllers support versions 1, 2c, and 3 of Simple Network Management Protocol (SNMP) for reporting purposes only.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |